[1]刘 莉,许 喆,高 峰.城轨车辆司机室端部主吸能结构优化设计[J].机车电传动,2020,(01):139-143.[doi:10.13890/j.issn.1000-128x.2020.01.121]
 LIU Li,XU Zhe,GAO Feng.Optimization Design of Main Energy-absorbing Structure Fixed onthe Cab End of Urban Rail Vehicles[J].Electric Drive for Locomotives,2020,(01):139-143.[doi:10.13890/j.issn.1000-128x.2020.01.121]
点击复制

城轨车辆司机室端部主吸能结构优化设计()
分享到:

机车电传动[ISSN:1000-128X/CN:43-1125/U]

卷:
期数:
2020年01期
页码:
139-143
栏目:
城市轨道车辆
出版日期:
2020-01-10

文章信息/Info

Title:
Optimization Design of Main Energy-absorbing Structure Fixed onthe Cab End of Urban Rail Vehicles
文章编号:
1000-128X(2020)01-0139-05
作者:
刘 莉许 喆高 峰
(中车唐山机车车辆有限公司 技术研究中心,河北 唐山 063035)
Author(s):
LIU Li XU Zhe GAO Feng
( Technology Research Center, CRRC Tangshan Co., Ltd., Tangshan, Hebei 063035, China )
关键词:
城轨车辆碰撞吸能结构吸能性能仿真分析有限元模型
Keywords:
urban rail vehicle crash energy-absorbing structure energy-absorbing performance simulation analysis finite element model
分类号:
U239.5;O313.4
DOI:
10.13890/j.issn.1000-128x.2020.01.121
文献标志码:
A
摘要:
为了提高城轨车辆司机室端部主吸能结构的吸能性能,采用仿真分析的方法对底架端梁和吸能结构的板材厚度进行了优化设计。考虑优化部位对吸能量的影响,建立某城轨车辆司机室车与司机室车以相对速度25 km/h的正撞模型,通过碰撞分析计算得到了结构优化前后的吸能量及车体不发生压溃的最大撞击速度。研究结果表明:提高底架端梁结构的刚度,减小主吸能结构的板材厚度能够满足司机室端部吸能系统的顺序可控变形规律,其吸能性能也得到提升,为主吸能结构的优化设计提供了理论参考。
Abstract:
In order to improve the energy-absorbing performance of the main energy-absorbing structure at the cab end of the urban rail vehicles, the underframe end sill and the sheet thickness of the main energy-absorbing structure were optimized by means of simulation analysis. Considering the influence of optimal location on energy absorption, the collision model of cab car versus cab car modal of one urban rail vehicle with a relative velocity of 25 km/h was developed. The maximum impact velocity without crushing and the energy absorption before and after structural optimization were obtained by collision analysis and calculation. The results showed that increasing the stiffness of the underframe end sill and reducing the sheet thickness of the main energy-absorbing structure can satisfy the orderly controllable deformation law of the cab end energy-absorbing system, as well as the energy-absorbing performance can be improved, which provided a theoretical reference for the optimization design of the main energy-absorbing structure.

参考文献/References:

[1] 张乐乐, 张啸雨, 崔进, 等. 地铁头车车体耐撞性仿真分析[J]. 铁道学报, 2012, 34(3): 22-27.

[2] 杨慧芳. CRH3动车组被动安全性和耐撞性优化研究[D]. 大连: 大连交通大学, 2010: 1-20.
[3] 刘金朝, 房加至, 王成国, 等. 铁道客车大变形仿真研究[J]. 中国铁道科学, 2004, 25(6): 1-8.
[4] 姚松, 田红旗, 高广军. 显式有限元法在车辆耐撞性研究中的应用[J]. 交通运输工程学报, 2003, 3(1): 13-16.

相似文献/References:

[1]文 娟,李 芾,杨 阳,等.城轨车辆弹性车轮参数优化及其线路适应性研究[J].机车电传动,2015,(03):74.[doi:10.13890/j.issn.1000-128x.2015.03.020]
 WEN Juan,LI Fu,YANG Yang,et al.Parameters Optimization and Track Adaptation Researchof Urban Vehicle Resilient Wheels[J].Electric Drive for Locomotives,2015,(01):74.[doi:10.13890/j.issn.1000-128x.2015.03.020]
[2]段继超,高小波,王伟波.城轨车辆低粘着条件下紧急制动减速率研究[J].机车电传动,2015,(05):50.[doi:10.13890/j.issn.1000-128x.2015.05.014]
 DUAN Jichao,GAO Xiaobo,WANG Weibo.Research on Emergency Brake Deceleration Rate of Metro Vehicles under Low-adhesion Condition[J].Electric Drive for Locomotives,2015,(01):50.[doi:10.13890/j.issn.1000-128x.2015.05.014]
[3]余接任,钱华,夏 帅,等.城轨车辆制动防滑检测与保护[J].机车电传动,2015,(02):94.[doi:10.13890/j.issn.1000-128x.2015.02.023]
 YU Jieren,QIAN Hua,XIA Shuai,et al.Brake Anti-slide Detection and Protection for Metro Vehicles[J].Electric Drive for Locomotives,2015,(01):94.[doi:10.13890/j.issn.1000-128x.2015.02.023]
[4]王烟平.城轨车辆VTCU插件故障分析与维修[J].机车电传动,2014,(05):84.[doi:10.13890/j.issn.1000-128x.2014.05.023]
[5]周 升,曾凡辉,王浩新,等.城轨车辆受电弓安装区用绝缘防护涂层的研究[J].机车电传动,2015,(06):60.[doi:10.13890/j.issn.1000-128x.2015.06.016]
 ZHOU Sheng,ZENG Fanhui,WANG Haoxin,et al.Research on Insulation Protective Coatings for Pantograph Assemble Position of Urban Rail Vehicle[J].Electric Drive for Locomotives,2015,(01):60.[doi:10.13890/j.issn.1000-128x.2015.06.016]
[6]姜悦礼,史秀娈,董明.城轨车辆牵引系统的安全性设计与评估[J].机车电传动,2013,(01):55.[doi:10.13890/j.issn.1000-128x.2013.01.008]
 JIANG Yue-li,SHI Xiu-luan,DONG Ming.Safety Design and Evalation on Traction System of Mass Transit Vehicles[J].Electric Drive for Locomotives,2013,(01):55.[doi:10.13890/j.issn.1000-128x.2013.01.008]
[7]张志新,田爱琴,车全伟,等.高速列车车体端部吸能结构研究[J].机车电传动,2013,(01):43.[doi:10.13890/j.issn.1000-128x.2013.01.027]
 ZHANG Zhi-xin,TIAN Ai-qing,et al.Research on Energy-absorbing Structures for Two Endsof High-speed Train Car Body[J].Electric Drive for Locomotives,2013,(01):43.[doi:10.13890/j.issn.1000-128x.2013.01.027]
[8]李大众.城轨车辆的电磁屏蔽与接地[J].机车电传动,2013,(06):61.
 LI Da-zhong.Electromagnetic Shielding and Grounding for Urban Transit Vehicle[J].Electric Drive for Locomotives,2013,(01):61.
[9]周帅,张小勇,赵清良,等.城轨车辆高频隔离辅助变压器的设计[J].机车电传动,2017,(01):94.[doi:10.13890/j.issn.1000-128x.2017.01.022]
 ZHOU Shuai,ZHANG Xiaoyong,ZHAO Qingliang,et al.Design of a High Frequency Isolation Auxiliary Transformer for Urban Rail Vehicle[J].Electric Drive for Locomotives,2017,(01):94.[doi:10.13890/j.issn.1000-128x.2017.01.022]
[10]岳译新,刘永强,苏柯,等.APM车辆车体结构设计[J].机车电传动,2017,(01):102.[doi:10.13890/j.issn.1000-128x.2017.01.024]
 YUE Yixin,LIU Yongqiang,SU Ke,et al.Design of Car Body Structure for APM Vehicle[J].Electric Drive for Locomotives,2017,(01):102.[doi:10.13890/j.issn.1000-128x.2017.01.024]
[11]刘莉,许 喆,高峰. 城轨车辆司机室端部主吸能结构优化设计[J].机车电传动,2020,(01):1.[doi:10.13890/j.issn.1000-128x.2020.01.121]
 LIU Li,XU Zhe,GAO Feng. Optimization Design of Main Energy-absorbing Structure Fixed on The Cab End of Urban Rail Vehicles[J].Electric Drive for Locomotives,2020,(01):1.[doi:10.13890/j.issn.1000-128x.2020.01.121]

备注/Memo

备注/Memo:
作者简介:刘 莉(1987—),女,硕士,工程师,主要从事轨道车辆强度仿真分析工作。
更新日期/Last Update: 2020-01-10